I Need Henredon Drawer Pulls  

Does anyone know where I can get 3 Henredon drawer pulls for the Heritage line. I believe they are walnut. I have the hardware that attaches them, I need the wood. (I'd be happy to buy them complete if I had to or have someone make just the wood handle. 
The wood measures 8" (I need 2) and 6" ( I need 1)
Thanks all!

Anybody with a lathe can make that. The larger problem is going to be color matching. It is walnut that has been stained walnut color for consistency and then both have changed color over the decades.  And the precisely reflectivity of the finish is going to affect the perceived color. So you should plan to be forgiving when you specific walnut and they don’t match well or you should plan the secondary steps that will get a good match. 

Agree that those spindles would be simple to replicate for someone with the right tools and experience. Try contacting your local crafts guild if all else fails. Chances are there's a local craftsperson that would be happy to whip off a few of those for you.

Thanks Leif, I found a company that does only wood turning and they did them reasonably.

Hi,

I am looking for two of these as well. Do you have the contact info for your supplier? Many thanks!

I would also appreciate a source.

I need One

http://www.keystonewoodturning.com/

http://www.keystonewoodturning.com/

http://www.keystonewoodturning.com/

http://www.keystonewoodturning.com/

Hi Frankie,

How are you? Thank you so much for the source!

Would you happen to have any extra hardware?

I just need 1 metal hardware end that holds the dowel.

If not, Any idea of a source?

Thanks again for your help !

Hi,

I noticed that this thread went dry. I'm also, as Russ7 above, looking for the end-pieces/escutcheons for the wood dowel portion. I need two of them to support one drawer pull that I'm trying to reconstruct. Any help or suggestions would be so appreciated. I'm bleary-eyed from looking online for the parts 🙁

Nancy