Design Addict

Cart

Source for George N...
 

Source for George Nelson credenza sliding finger pull?  

  RSS

cysco
(@cysco)
Eminent Member
Joined: 15 years ago
Posts: 33
09/04/2015 3:03 am  

Hey all,I have a George Nelson credenza that I've been refinishing. When I found it, it was being used as a chicken coop. It had been painted white and seriously had chickens living in it. lolAnyway, the sliding panel that is in the front was long gone so I made a replacement however I can't seem to find the proper size finger pull.Anyone know where I might find the right pull? Or, at least close enough?The below photos, the first one is my nearly finished credenza. The second is the size pull I would have expected to be on it. Any direction would be greatly appreciated.     


Quote
toomanychairs
(@toomanychairs)
Trusted Member
Joined: 15 years ago
Posts: 71
09/04/2015 5:27 am  

What's the diameter of the pull you want?


ReplyQuote
cysco
(@cysco)
Eminent Member
Joined: 15 years ago
Posts: 33
09/04/2015 8:57 am  

"What's the diameter of the pull you want?"
That's a good question. By the looks of it, the original one appears to be 1in total diamater with maybe a 3/4in inside. I'm hoping someone can confirm. I think the bigger issue is finding one in that diamater with a depth that isn't too deep. the pull is on/in a pretty thin piece of melamine. Most of the pulls i've seen are thicker  and are intended for use in pocket doors and such. These have a deeper profile and would protrude too far out the back of the material if that makes any sense. 
 


ReplyQuote
tktoo
(@tktoo)
Illustrious Member
Joined: 15 years ago
Posts: 2287
09/04/2015 4:18 pm  

Lots of hits.
Search "3/4-inch sliding bypass door finger pulls".


ReplyQuote
Share:

If you need any help, please contact us at – info@designaddict.com

  
Working

Please Login or Register