Hi
I managed to pick up a tongue chair off ebay [i think its teak] and need some advice on restoring the chair
I plan to remove the screws the previous owners put through the seat and metal casing... should i replace these with real veneer or fill and paint them out? what is the best way to revive and re finish the wood? and any idea where you can pick up replacement rubber feet?
and what is the best way to clean rust off the metal work
also can anyone tell me the year of production?
thanks in advance
rols
http://d1t1u890k7d3ys.cloudfront.net/cdn/farfuture/6sjo_Nm5nuTkaQ_hOMVe3iK0BtrutPeeVOZvHRkIlFw/mtime:1487882345/sites/default/files/forum/11-1.jp g" /><img class="wpforo-default-image-attachment wpforoimg" src=" http://old.designaddict.com/sites/default/f
so far
rols.
So far I have this information:
Description: FH 3102. Fritz Hansen produced the Tongue chair in 1999, this was the last year of production. This chair was designed in 1955 for Munkegård Elementary School.
I regret that I do not have more details at this time. My black Tongue chair is from 1999.
Good luck.
Maybe walnut?
Either way, the face veneers are nicely book-matched. Too bad about the screws, but they're there for a reason, ya? If they're holding tight, you might consider leaving them. A complete restoration would require little veneer patches, but, unless those are done exceptionally well, the diamond pattern will still show like a sore thumb. Filling and inpainting might be the way to go on this one.
thanks for the advice
will...
thanks for the advice
will need to track down a square headed screw driver in the u.k. since there are some screws poping through the base...lets see what happens.
What would be best finish for the wood...clean with wire wool and methelated spirits followed by a clear shellac?
r
all or nothing
rols,
I agree with tktoo that unless "done exceptionally well" any patch will be obvious. The word "restoration" is the key.
Money well spent in a thorough "professional restoration" will yield years of pleasant service. A "short term investment" for a "long term gain".
rols, technically, those are "Robertson" screws.
Popularly called "square-drive" here in the US. Superior to Phillips head for power driving, IMO.
If you are concerned with retaining the patina of age, as I would be, start with white spirits or Stoddard's solvent and a linen rag. Save the stronger solvents and/or abrasives for the next steps if that doesn't achieve the desired results.
I like a wash-coat of shellac for its compatibility and ease of repair/removal, but others may disagree. *spanky* rightly pointed out recently that shellac might not be the best choice for seating surfaces, as a sweaty bum may cause embarrassment and an unsightly bloom to the finish. The dewaxed orange varieties can help to add depth to faded veneers, but oil works best to "pop" the grain. In this case, tung oil might be appropriate!
If you need any help, please contact us at – info@designaddict.com